Preview

Concrete and Reinforced Concrete

Advanced search

Comparative studies of moisture protection properties of the lightweight hydrophobic plasters on lightweight fillers in relation to aerated concrete

https://doi.org/10.37538/0005-9889-2024-6(625)-40-50

EDN: RYWDVC

Abstract

Introduction. One of the most important properties of facade plasters is their ability to resist the effects of atmospheric moisture or hydrophobicity. Water penetrates into the facade plaster layer by adsorption. In this case, the passage of moisture through the plaster solution is caused by capillary action (water absorption, moisture permeability).

Hydrophobization is a sharp decrease in the ability of materials to be wetted with water and aqueous mortars while maintaining vapor permeability. In this paper, a comparative study of the moisture-proof properties of lightweight mineral hydrophobic plaster based on foam ceramic granules "SPADAR", plaster mixtures with other similar lightweight fillers, in relation to aerated concrete. The values of capillary water absorption of plaster compositions, as well as water absorption by weight and the depth of water penetration into the body of aerated concrete samples uncoated and coated on all sides with the studied plaster compositions were compared.

Aim. To investigate the moisture-proof properties of a plaster composition with foam ceramic granules "SPADAR" and similar plaster compositions (on foam ceramic granules "KERWOOD" (another manufacturer), granular foam glass and perlite sand) in relation to aerated concrete.

Materials and methods. To conduct the study, previously developed lightweight hydrophobic plaster compositions for facade work with a dry density of no more than 600 kg/m3 and aerated concrete samples with a density of 600 kg/m3 were used. Water absorption by weight values of a control sample of aerated concrete, as well as aerated concrete samples coated on all sides with the studied hydrophobic plaster solutions were compared. The depth of water penetration into the body of these samples was also compared.

Results. Water absorption by weight of control samples of aerated concrete and plastered with lightweight plaster mortars and the depth of water penetration into the aerated concrete layer after 1.5 hours were established. The advantages of the plaster composition using foam ceramic granules "SPADAR" are revealed.

Conclusions. Based on the data obtained, the composition of a light hydrophobic plaster mortar was developed using foam ceramic granules "SPADAR" and further studies of these plaster compositions on vapor permeability and frost resistance are planned.

About the Author

A. N. Gudkov
JSC Tulaorgtekhstroy
Russian Federation

Alexey N. Gudkov, Head of the Laboratory of Building Materials and Technologies of the Design and Technology Center, JSC Tulaorgtekhstroy, Tula

e-mail: alekseygudkov2016@yandex.ru



References

1. State Standard 33083-2014. Dry building plaster cement binder mixes. Specifications. Moscow: Standartinform Publ., 2019. (In Russian).

2. Gudkov A.N. Comparative study of physical and mechanical properties of a light plaster mortar based on the "SPADAR" foam ceramic granules and similar light fillers. <i>Beton i Zhelezobeton = Concrete and Reinforced Concrete</i>. 2024, no. 4 (623), pp. 39–49. (In Russian). DOI: https://doi.org/10.37538/0005-9889-2024-4(623)-39-49

3. State Standard R 58277-2018. Dry building mixes based on cement binder. Test methods. Moscow: Standartinform Publ., 2019. (In Russian).

4. State Standard 30256-94. Building materials and products. Method of thermal conductivity determination by cylindrical probe. Moscow: Publishing house of standards, 1996. (In Russian).

5. State Standard 28013-98. Mortars. General specifications. Moscow: Standartinform Publ., 2018. (In Russian).

6. State Standard 5802-86. Mortars. Test methods. Moscow: Standartinform Publ., 2018. (In Russian).

7. State Standard 310.4-81. Cements. Methods of bending and compression strength determination (with Changes No. 1, 2). Moscow: Publishing house of standards, 2003. (In Russian).

8. State Standard 32496-2013. Fillers porous for light concrete. Specifications. Moscow: Standartinform Publ., 2014. (In Russian).

9. State Standard 31108-2020. Common cements. Specifications. Moscow: Standartinform Publ., 2020. (In Russian).

10. SP 82-101-98. Manufacturing and usage of solutions in construction industry. Moscow: Gosstroy of Russia, 1999. (In Russian).

11. Bazhenov Yu.M. Technology of concrete. Moscow: ASV Publ., 2002, 500 p. (In Russian).

12. Bazhenov Yu.M., Korovyakov V.F., Denisov G.A. Technology of dry building mixes. Moscow: Publishing House of the Association of Construction Universities, 2011, 112 p. (In Russian).

13. Korneev V.I., Zozulya P.V., Medvedeva I.N., Bogoyavlenskaya G.A., Nuzhdina N.I. Compounding guide to dry building mixes. St. Petersburg: RIA "Quintet", 2010, 318 p. (In Russian).

14. Korneev V.I., Zozulya P.V. Dry building mixes. Composition, properties: Textbook. Moscow: RIF "Building materials", 2010, 320 p. (In Russian).


Review

For citations:


Gudkov A.N. Comparative studies of moisture protection properties of the lightweight hydrophobic plasters on lightweight fillers in relation to aerated concrete. Concrete and Reinforced Concrete. 2024;625(6):40-50. (In Russ.) https://doi.org/10.37538/0005-9889-2024-6(625)-40-50. EDN: RYWDVC

Views: 76


Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 License.


ISSN 0005-9889 (Print)
ISSN 3034-1302 (Online)